Surface Geometry

As it turned out – the surface Still did not suffer so much as to renounce the possibility of recovery. If you would like to know more then you should visit Mitchel Resnick. Day of work needed a tinsmith, to recover the surface geometry. After graduating from the "rough" part, was invited specialist preparing surfaces for painting and gave his resume: the roof can be prepared, work tinsmiths accepted! Recovering the geometry of the frame It was the most important moment of repair – restoration of the geometry of the car kia Sorento. At this stage, the master with a laser "ruler" and the computer program again Gaugeable milestones and received data on the deformations produced in a car accident. As a result, it was found that the front part of the car, receiving a strong blow to the right shifted by 4 inches – hence can not do without seizures and powerful hydraulics bench. However, to bring to the ideal geometry (no tolerance for deviations of the points is less than 3 mm) it was necessary not to repeat the measurement and rearrange seizures. Last check clearances In order to check how effectively restored geometry of the body, car care professionals hung all over body panels: hood, doors, fenders, headlights and installed a new bumper.

By the way for this had to recover all of its fasteners – bracket-mount was destroyed blow. The assembly shown – the geometry of the body is fully restored, all body clearances match factory defaults, but oddly enough the next stage of repair was complete disassembly of the car. This is necessary in order to prepare the car for painting and drive into the painting chamber. Preparation for painting In order to proceed to paint the car was completely dismantled – with the body removed everything that could be dismantled. This allowed the maximum quality produce body parts to the work house painter. In the workshop held to prepare the machine for a week.

Details again are in place to conduct pilot test of geometry before painting, as well as check clearances on the body were navesheny prepared by members of the body – Everything except plastic bumpers, bonnet and tailgate.

Install Parktronic

Many car owners bought or received a parking radar parking sensors as a gift, start looking for the best and cheapest way to install it on the car. The most common way of motorists in Russia, to save their money is to install a parking radar independently or as they say their hands. Motorists talking with friends and acquaintances, having read various forums, looking at examples Installation, start to install parking sensors on the car with his hands, without worrying about warranty on your new car warranty parktronik himself and about the possibility nakosyachit. But when self- installing parking radar, with no special skills and knowledge you can say goodbye to the warranty on the equipment (for parking sensors – in the best case) or a new car (at worst), but when you install parking sensors on the any motor vehicle, interference with an established electrical wiring a car is minimal, it is better to entrust the installation of PDC professionals. Many motorists parking sensors installed at its authorized dealer, such method is very expensive, and car owners overpay for the installation of parking sensors already in three or more times the normal cost of installation, such as a certified installation center.

Best and not afford striker way is to install parking sensors in a specialized, certified installation center, for example: price installing parking sensors in the center begins to 2000P. depending on the number of sensors parking. Installing parking sensors in the center of the installation is performed by professional installers and takes from two to four hours depending on the purchased parking sensors and depending on the number of parking sensors. By After installing the client center, given the warranty card and a copy of the certificate to maintain warranty on new cars. Set the parking radar (Parktronic) and a park with pleasure!